Search results

I have an older clock with a two wire transformer and starter. It also has a round flourescent light. How does one wire to and from the transformer?

I have a Quincy compressor with a HP of SPL and 15 amps. Not sure what the HP is but thinking 3. Will the following work as a disconnect? SQUARE D BY SCHNEIDER ELECTRIC QO200TRNM 60A Non Fuse Disconect

This has been covered numerous times but I will try to explain what I need. I have 4 exterior garage lights and would like to add one remote exterior motion sensor to control all four lights.I presently have a control that installs in the switch and a remote battery sensor that is mounted...

Where are the best priced aluminum ramps for a Danmar 4 post lift?

I have some Gas pump panels available. Take a look.

My electrician is recommending #6 Aluminum wire to feed a new 100 sub panel from my house 200 amp main. The total run is 100 ft. Is #6 ok?

I am starting to wire my new 24 x 24 x 12 garage and have thought about recessed 2 x4 flourescent lights. http://www.drillspot.com/products/276753/Lithonia_2GT8_332_A12_MV1_3GEB10IS_Lens_Troffer_Fixture These are the ones I am looking at. Would six be enough?

I am ready to wire my 24 x 24 x 12 garage and would like to install recessed flourescents due to a car lift which I will install later. The ones I am thinking about are: http://www.drillspot.com/products/276753/Lithonia_2GT8_332_A12_MV1_3GEB10IS_Lens_Troffer_Fixture. They are four footers with...

I have a 3 phase 1750 rpm motor on my compressor. I would like to replace it with a single phase motor. Can I just replace and all will be ok?

Just picked up a Quincy QT5, used, and would like to know what to install on the discharge end. Is it ok just to go directly to my tools from the tank? Can I use other oils?