Search results

Selling a variety of sockets and wrenches. Please see following posts for more info. Prefer to sell in bundles to save time and money. Willing to sell separate though. No prices include shipping which will be added onto for a final price. Sockets Crescent sockets (whole bag) - $10 KAL sockets...

I've been looking for a good, used Wilton C2 for over five years now. I found one for $625 and bought it for my brother. Never saw another like it since. I finally have the chance through some discounts to bring the usual $1820 price tag down to $~1300.

I got it in an auction with two vises. I'm about to toss it if I can't figure out what it is.

I have 240V going from the electrical panel to the plug. I use this outlet for my compressor and welder. Now I'm installing this ceiling heater and I can't decide how I want to wire it. I would like to keep the wall as clean as possible, so surface mount PVC conduit isn't my preferred method...

This is my 6" jointer motor. It started to buzz when I turned it on until I spun the shaft, then it would spin right up. Now it just buzzes and won't spin at all. Research says it's likely the starter capacitor. The numbers on the capacitor are gone due to corrosion. The original manual...

Hey, all. It's $150 and it's a three hour drive away. I know she doesn't have the double belt setup for drilling big metal, but what do you think about using it for home gamer shop use? I'm not doing anything much heavier than some automotive work in my shop. Honestly, I don't know much...

Hey all, My new chainsaw chain is grabbing and skipping on the chainsaw sprocket, as if it has a different number of drive links than the old chain. It's the same specs: 16", 56 drive links, .050 gauge. The old chain is made by Oregon and the new one by Trilink. I'm under the impression that...

I have a couple aircraft that I can do my own work on without an A&P license and will have more in my future. I have the 1/2" drive Tekton torque wrench for vehicle lug nuts and suspension components and it has worked okay. Now I'm looking for a 3/8" drive. There have been a few instances...

I have a paramotor that I want to safety wire a lot of small nuts and bolts on. The bolts are four and five millimeters. Does anyone have experience drilling these with a safety wire jig or with any other method? Any advice?

The small needle nose are my favorite set of pliers and I've never been able to find out who makes. This is my last shot. It appears that all of these pliers came in a set, or were at least from the same manufacturer. Does anyone know who made them? Trust me, I know there's not much to go...

50/50/90 Rule: If you pick up a non-switching ratcheting wrench, you have a 50/50 shot that it's going to turn in the right direction when you put it on the fastener. 90% of the time, you'll be wrong. :lol_hitti I have the GearWrench ratcheting wrenches that require you to flip them over to...