Search results

Search the forum Search Articles
  1. G

    Craftsman Green Tool? Box

    Another garage sale find. $2.00. Looks like a cross between a machinist tool box and a jewelry box. When I first saw it I thought it was plastic. The lock and drawers work well. Any idea what year it is?
  2. G

    Help Identifying Garage Sale Finds

    I purchased these two motors at a garage sale for $5 for the pair. The 3/4 horse GE is mounted (sort of) to some kind of a pully drive. The SKF bearing decal looks very similar to a decal on my Atlas/Craftsman lathe. The 1/2 horse Craftsman with wire wheel is much too fast for my wire wheel...
  3. G

    Jack Identification Help

    I picked up this jack at a garage sale last weekend for a couple bucks. Anyone know any info on it? It works like a turnbuckle when the center section is rotated axially. There is a "pull & flip" tab with "up" and "down" stamped into it that doesn't seem to change how the jack operates.
  4. G

    Removing a Split Pulley

    I know someone here will know. I've never seen this before. I purchased this Craftsman "Fan Duty" motor at a garage sale for $17.50 to use on my old Craftsman King Seeley DP. How do you remove this type of split pulley from the motor shaft? The outside piece threads unto the inside and is...
  5. G

    Help with Identification

    Anyone know what this is? Looks cast iron with the markings M196 on one side and a 6 or a 9 on the other. Also there is a mark that looks like two capitol "Y"s tail to tail. About 7-1/4" long and the square is slightly larger than 3/4" x 3/4".
  6. G

    Walker Turner Drill Press Identification

    Can anyone tell me what year this DP is? I found one with the same head badge on Vintage Machinery that says it's a 1939. But it has a serial number and mine does not. My searching has turned up very few WTs with this head badge. thanks
  7. G

    WTB Parts for Craftsman King Seeley DP

    Needed to complete a restoration on a 103.23641 drill press. Original motor including the step pulley - I think the pulley part number is 18811-103 but I'm not certain. It is a 5" dia (at big end), 1/2" ID without a keyway. Looking for either or both. thanks
  8. G

    Size of Gib Screws on a FPU Vise

    I just acquired a FPU vise and it is missing one gib screw. The diameter appears to be between a metric 7mm and a 5/16" imperial. The thread per inch are very close to the 5/16-18 but the diameter is smaller. Anyone know this info? thanks
Top Bottom