Search results

I purchased a 240v water heater for my shop sink. I ran 10/2 romex to a 2 gang box during construction. The heater has 3' of wiring already attached. Should I terminate this inside the 2 gang box? Do they make a cover where the wire can go into the front of the box? (the box is surrounded...

Current shed has a 3 wire subpanel fed from a 100 amp breaker at the meter/combo box. Bonding screw installed. I do not see a ground bar at this panel. New shed is attached to the current shed. The meter is actually closer to this new shed, so we plan to run 4 wire to the meter/combo box with...

I’m installing two 60“ industrial ceiling fans in my new pole barn. I see most switches are rated up to 1.5 amps. A single fan, on high speed, uses 1.04 amps. Will the switch “burn up” if I install 2 fans on 1 switch? Basically 2 amps on high through a 1.5 amp switch.

Should the bare copper ground wire be connected to its current location or the actual ground bar? I have a homeline combo box (8 space panel and meter) with a 4 space 200 amp breaker feeding this panel in my new shed. The electrician only ran 3 wire 4/0 feeder back to the combo box. The bare...