Search results

I bought this old press at a garage sale several years ago for $5. Anyone familiar with It, I haven’t turned anything up on the internet

I bought this used Clean Burn 1800 yesterday and am ready to start tinkering with it and bench test it before I install it. It’s a date code 11/98 and has 15,000 hours on the burner. The guy I got it from got it on a trade and said it was used in a barn to supply heat for a guys dogs and was...

So I am installing my new BendPak lift and I’m trying to figure out what all I need to go along with it and where’s a good place to buy decent quality stuff. Figure I need an oil drain setup and some high rise jack stands at least but wondering what else you guys figured out was needed and comes...

I picked up my BendPak XPR10-XLS and am getting ready to install it. The manual says to use a thread locker like Loctite 5452 on the NPT fittings. I found that loctite 545 is another similar and Permatex 54540 but the thing is I can’t find any of them anywhere and it will take till mid week to...

My pole barn is 30 x 56 x10 and from the concrete to the bottom of the existing truss is 9’6, trusses are 4-12 pitch set on 8’ centers. I want to install a 2 post 10,000 lb lift and need at least 12’4 for the span of the lift which is around 12 foot wide. I have been looking at steel trusses...