Search results

I'll try to keep this short. A few months ago I took a craftsman screwdriver in for warranty replacement. It was a flat blade and the corners were worn off. It was old and had a grove melted in the handle as well. The damage to the handle was cosmetic. When I presented at the counter...

I have a 10acx. Just got it up and have a couple of questions. AS you know the instructions are less that perfect. I need to know just how the foot guards are supposed to look when installed. I don't see anything in the written instructions and no clear pictures. Also, the fitting that operates...

I am geting ready to order my two post asymetrical lift. It's a long story but I am not able to put it where I had intended. I am now having to try to avoid windows, expansion joints, etc. The longest vehicle that will be on the lift is an F-150 super cab (about 20'). Does anyone know where the...

Hi everyone! I'm getting ready for winter and I'm going to put heat in this thing before it gets cold. I've decided on the Northern "Big Maxx" heater. I figure it will be neat and clean and heat things up quickly. My problem is the proper size for my situation. There are 45,000 and 75,000 BTU...

I haven't found much on this and could use some help. I have a new floor so no oil stains etc...yet. I really don't want to go the epoxy route because this will be a working garage and I don't think epoxy will hold up. What I do need is to seal the concrete so that oil etc does not soak in. Can...

I’ve been looking at doors for my 30x40 project. I’ll need two 12x9 and one 10x9. Does anyone have an opinion or experience with the Clopay premium, Wayne Dalton 9100, or the Amar 3000 series? The Dalton is the thinnest but has the better insulation. It is also the less expensive. Thanks!

OK, I think that I can post pictures now. Here is my build. I was a little lax on the pictures but here we go. We got the one of the largest rainfalls in history as soon as we started!

Test post of image.

I have followed the directions but when I try to upload pictures all I get is "File upload failed". Any suggestions?? Thanks,

Just getting started on my 30x40. Eventually I will be installing a two post lift. I would like to plan placement now so that I can pour deeper for the lift bases. My longest vehicle will be an F-150 (about 20'). How far will the lift need to be inside the overhead door in order to have room to...

I am building a 30x40 stick built. The idea is to add a 2 post lift later. Along with deciding where the post will go and putting thicker footings there, I am in a jam as to ceiling height for the lift. I will be putting an F-150 on the lift as the tallest vehicle. I see that the Bend pak 10acx...