Search results

I just got a older speedaire 3z172. It looks to be the same as a champion s20 pump. I will be running it with a baldor 1phz 5hp 1725rpm and mag starter. What rpm should I shoot for when picking the motor pulley? It shows max of 1000rpm. Should I get as close to that as possible? max psi of...

I installed my rotary 10k a few months back, everything went as it should. Torqued to 90ftlb and called it done. Fast forward to last week, finished my rough in electric and turned on all my bright *** lights... Noticed a hairline crack running from two anchor bolts on one side lift post. The...

I have 9 of the led lithonia ibh15000 lights to install. What kind of spacing should I have between these? Building is 30x50, but they will be in a 30x40 area. The other 10x30 section will have mezzanine, so different lighting. All vaulted ceilings, 14' side wall, 18'6" peak. Also, the specs...

I have a line on a used rotary spoa9-200 for 1300$. Will I be happy with this lift for 3/4-1ton dodge diesels cc/lb. I know it will be fine for the cars I want to lift. I'm sure I will be pulling trannys/cases and doing suspension work on these trucks. I don't want it to be sketchy or a pain...

Not quite to the insulation stage, but want to figure it out now. Have a build thread in garage gallery :beer: The building is a Websteel, vaulted truss and clear span. 12-14' spans between truss/columns. The purlins are 2x8 on edge parallel to ridge. Websteel recommended using condensation...

Brzerk shop build: Websteel 30x50x14 with 30x16 addition Greetings all, figured i would finally start a thread for my shop build that is in progress. Let me start by saying this site is a wealth of knowledge, greatly appreciated! The property: 1.6 acre inner city lot in the rainy PNW. i...