Search results

I just acquired a 1940's Atlas benchtop press from FB Marketplace and I'm a bit confused about the motor wiring. The motor is a K-C Bearing motor (from North Plainfield NJ!) that can do both 110 and 220v. According to the wiring diagram, I *believe* the motor is currently wired for 220 but it...

My only workspace is a 10' x 12' shed powered by an extension cord run from the house. Ceiling is 7' and I'm located in NJ, so not terrible winters but it definitely can get cold. Any ideas on how I can stay warm? I've run a 1500w heater to "pre-heat" the shed in the past, but I need to turn it...

Hello all! I bought this Snap-on toolbox at an estate sale the other day for $80 (I think it was a good deal?) and plan on restoring it. Is it at all possible to remove the hinge pin so that I can take the lid completely off? It would make my life a LOT easier. I've tried tapping at it with an...