Search results

So the the guy that I bought my house from had a MaxJax installed in the garage. I wanted to buy a new MaxJax M7K kit and wanted to know what your thoughts are on installing a new kit using the old anchor bolt locations. I would prefer to do this rather drilling new holes into the concrete. The...

I was changing the oil on one of my older Honda 4 cylinder engines where the oil filter mounts sideways (parallel to the ground). Normally, quite a bit of oil dumps down the side of the block when the filter is removed. This time nothing came out of the filter. I held the filter upside down and...

I'm taking my power steering pump apart to replace the leaky o-rings and seals. I'm stuck trying to remove this c-clip. I have an assortment of small flat head screwdrivers and picks, but I can seem to get anything under or behind it to pry it off. Is there a special tool to spread the ends apart?

So about a year ago I picked up the #2 and the #3 Impacta screwdrivers. I used the #2 for the first time a couple of months ago to remove the strikers for the rear hatch on one of my cars. It took several good hits, but it did the job and I was able to remove the screws without too much trouble...

I'm working on rebuilding a set of adjustable coilovers for one of my cars. The the first couple of threads at the end of the struts shaft either weren't cut correctly or it was damaged at some point during the manufacturing process. If I try to carefully screw the nut on, I can get it maybe...

Hey Guys, So I just bought a house this past August with a pretty nice (for me) 2 car detached garage where I can work on my cars and motorcycles. The previous owner of the home had worked for several NASCAR teams over the past ~20 years as a machinist. He left me an old Snap On tool box, which...