Search results

I have some automotive Oetkier clamps (Oetiker 167 and 154 stainless clamps) to install soon and was wondering if I could use the ratcheting PEX ear clamp tools to do the job, or if I need to get a Oetiker specific tool. I've got both an Iwiss and iCrimp F2098 ratcheting PEX crimp tools. Will...

Is this sort of mis aligned ratcheting end broaching normal for gearwrench ratcheting wrenches?

I was wondering if anyone knew of some off the shelf tools that could record torque vs angle and output the curve to a csv or some other file for analysis. Most torque wrenches I know of only display live readings or peak readings.

I'm looking to get a mid rise scissors lift installed in my 3 bay garage with low (8') ceilings. I want it to be flush mounted so I can easily been driven over and parked on when not in use/not become a tripping hazard. I'm looking for open access to the center of the vehicle as well. I've got a...

I was wondering if anyone knew if it was possible to swap in the Tekton rebuild kit for their split beam torque wrenches into a PI split beam torque wrench. I'm finding it annoying/difficult at times to get the swing angle I need to torque some suspension fasteners at times.

Does anyone have suggestions for something like the Lang Tools re-threading taps but for smaller threads like M4 or 10-32? I don't want to cut new threads just clean out corrosion and old Loctite in things like motorcycle cases etc. Long shank versions would be a plus. Lang Tools tap for...

I was looking for some long or extra long double box end wrenches in metric and was wondering what offerings were out there. So far all I have found are the following: Snap-On Nepros KTC Capri Deen (not sure if these are TW or Japan made) Daytona (I think these are a TW made house brand) Signet...