Search results

Anyone have instructions on how to build your own parts washer???

I managed to break off the battery post on my ATV battery while removing the wire terminal. All that is left is a flat piece of the post. Is there a way of repairing the post, maybe by pouring a new one out of lead or something. HELP

Any ideas on how to make a stand for my compact bender. I don't want to have it fixed to the floor but rather be able to move it back in a corner when not in use. It will need to be able to fasten down though so that I can bend metal without it moving around. Tks

Looking for some home-made ideas of how to hang tools, etc from the ceiling of my garage to maximize space.

I only have a 5 gallon air compressor (90 psi). What can I get for an impact gun which will actually remove the lug nuts on my truck. The one I have is garbage. It won't even turn them on the highest torques setting. Or is there something different I should do with the gun. Not familiar with...

My garage floor is concrete and has never been sealed. I want to find something that will cover those satins and make the floor look a lot better. I found a product called HARDROCK. Anyone use it? It is very expensive (primer, hardrock and sealer) runs around $100 per 100 square feet. If...

I am looking for really effecient ways to organize all my tools in my garage. For example (bench grinder on stand located next to what?:, cut off saw where, etc.......). Anyone know of any good spots to look for plans?

I broke the drive shaft on my truck. Dodge Ram 1500, 1997. It sheared right off (damn thing). How hard is it to replace it? Do I have to jack it up first and then unbolt the rear and then pull out the other end out of the transmission?

How can I convince my fiancee to have wild *** on my creeper?

I have a really cool garage but it is missing those funky hideaways spots, pull down drawerss in the ceiling, under the floor spots, etc. Anyone have any plans for this kind of stuff. Spots to hide small parts, sort projects, etc. Any web sites too would be a help.

Hi there, picked up a bench made of 2" metal pipe . It stands 4 feet by 4 feet by 30" high. No top on it yet and I want to do this very economicalically. I wanted to put a metal top but even a sheet of 1/4" thick sheet metal runs me over $200. Any suggestions. I think that a plywood top...

Anyone know how to make a scroll bedning attachment for a compact bender, I want to be able to make continuous bends (scroll) for ornamental ironwork. Or else does anyone know hot to build their own scroll bender. Thanks.

Anyone know of any good sites to find metal working projects with iron mostly. I want to start making some small tanles, plant hangers, etc. Thanks

I have a 5 gallo Coleman compressor. Can I leave it compressed all the time, never drain it only once in a while.

I purchased a compact bender and do not know how to use it. It did not come with any instructions. Can someone direct me to a website with very detailed instructions on how to make tyhe various bends in pipe metal. It came with various round dies and also a square block. What do I do with...

I have a small crack on my basse pan of my four wheeler. Can I weld it? I used JB-Weld but don't really trust it to work for long

Any ideas on how to build a stand for a drill press and another for a bench grinder. Simpler the better

If my tile lines don't line up perfect, does it matter when I go to grout them? Will ther grout cover the imperfections Not off line a lot but a little

Anyone have any ideas where to find names for a Garage. Maybe an Internet Site with a laundry list of names?

I have a mastercraft circular saw (only a couple years old but can't find reciept). It has seized up somehowq. How can I repair it. What do I do to get it spinning again. Thanks.