Search results

I currently have 50 amp service for my pool and dilapidated pool house. I’m going to be needing ideally 125 amp for the new pool heat pump and adding a small heat pump to for the new structure to cover my needs. The run is down a hill and very straight, however the existing conduit goes under...

I’m going to be getting Solar ahead of nem 3.0 and found out today that this may cost a lot more than I had hoped. According to the installer, I need a place to land a 60 amp breaker and there currently is no room in the main panel. Normally this isn’t too big of a deal, but they added that this...

Its time to get this beast going. I was about to start this about a year ago when I got it and then I moved and took it with me across the country. I’m looking for advice on which direction to go on this as it appears I have several options. If you need more info from the Pics, I will try to...

If an electrical expert could help would be greatly appreciated. I recently got a new pressure washer from northern tool. It is the 5hp North Star 3000 psi 2.5 gpm one. It runs on 230v on a 6-30r nema plug. I have wired in short run to a new receptacle. I used 8ga wire and a 30 amp breaker. The...

On the last house I owned, I properly ran black steel pipe for gas, however we recently moved and currently renting. So, I'm limited to "modifying" the property. I currently have a 40,000 BTU grill, I live in CA and homes are built on a 2ft truss. In this truss (if I'm using the term correctly)...

Bought a new Furnace and a new AC for the house a few weeks ago online. It is a Goodman 2.5 14.5 Seer and 96AFUE 80k BTU Split system. Furnace is variable speed. I did the furnace duct work ect. No problems on that end. I had Standard heating and plumbing come out to braze the AC, vac down the...

The Mandarin Garage This is my first house and first garage so mistakes will be made and learned from. I'm in my 20's so I don't have near the experience or spare change as some, but I attempted to make the best with what I currently have. Most of the pictures are from the progress throughout...

Thought I had room for both, but sadly I don't. Table is welded square tubing that is welded not bolted. The top is laminated plastic over wood. It is very sturdy and heavy. The dimensions are 45" tall 10' long and 30" wide. If your tall like me and prefer to work on stuff more in the air this...

I'm a bit new and new to the forum, so I apologize for the questions if they seem odd. I have never owned an air compressor this size before. I have owned a 25 gallon direct, but not an oil. I recently bought this air compressor and have a few questions about it. I have tried to call the...