Search results

Search the forum Search Articles
  1. C

    Jet/Wilton 8201 bandsaw no low speeds

    I just bought a barely used Wilton 8201 14" Wood/Metal Bandsaw, which is the same as the current Jet 8201. Motor is running fine, belts and pulleys spinning, blade/wheels turning with clutch pushed in the high speed position, all is good. With the clutch knob pulled out(clutch disengaged)...
  2. C

    auxillary ground bar in main panel, need to bond it to neutral bus bar

    I'm adding an auxillary ground bar(will only land EGC on it) in main panel to free up a few neutral terminations on the neutral bus bar, do I need to bond it to the neutral bus bar? I think it should be bonded to the neutral for the breakers to work correctly. thanks, Brian
  3. C

    Yet another slab/pad question

    This is regarding a hot tub pad(not necessarily shop related but right next to my small back yard shop! Shop is raised floor on piers) so if this isnt appropriate for this forum please delete. Site of pad is 125' +- from the street; I'm having a pumper because the elevation is around 30' higher...
  4. C

    Compressor won't build pressure mystery

    I recently bought a used Sears 60gal compressor, had a leaking head gasket so I replaced it. I ran it to test and it was up to 80psi when i shut it down, no air leaks. A day later I ran it and the tank pressure gauge stayed at 0, since the gauge was oem and pretty beat I bought and installed a...
Top Bottom