Search results

Am seeking a used Mohawk USL-6000 scissor lift. If anyone has a lead on one, could you please pass tthe info on to me via email sent to - gdy.lrconsult -at- gmail -dot- com. I would appreciate it!

The ceiling fan in my garage has no negative impact on my fluorescent lighting whatsoever.

The ideal floor tile, to me would be: 1. Interlocking 2. Permit water drainage. 3. Permit use of floor jack/jack stands 4. Reasonable in cost Any recommendations for a product that meets all these specs?

Unless you have unlimited funds to throw at such a project, as has already been discussed, building codes make construction of a pit almost cost prohibitive. There are stringent electrical, ventilation and drainage requirements. Far cheaper to go with a lift; even a very, very expensive one!

I built my own 12 x 20 shed. I used a gambrel roof. The advantage of it is that it gives me a readily accessible, large upper storage space. Using the gambrel rool is like adding a 1/2 story to the structure. It does have vents in the storage area. I also have 2 windows in opposing walls...

I built my own 12 x 20 shed. I used a gambrel roof. The advantage of it is that it gives me a readily accessible, large upper storage space. Using the gambrel rool is like adding a 1/2 story to the structure. It does have vents in the storage area. I also have 2 windows in opposing walls...

Maybe it is possible to purchase twice the amount of 3/16" pegboard for less than enough to use a single-layer of 1/4", but I doubt it? Secondly double layered 3/16" will do no good unless the two layers are solidly connected to one another. Then, once tied together, I doubt that any available...

30 gal. weighs in at 240 lbs., per my calculation?

The mere title to this thread made me laugh!

Milwaukee

I am sure NAPA sells exhaust ports, as that is where I got mine. Years ago, I believe it cost me $49? My recollection is that I traced the opening outline, drilled holes all the way around to remove, and then used a half-round file to clean things up. The ring covers the opening, so beauty...

Believe it or not, Mohawk has a Facebook page. You might try asking there, or on te Mohawk site itself.

You want to run the electrical feed, cable/satellite feed, tel/modem line and maybe even water to that detached garage. I ran all except water, and now wish I had run it!

Winmon Talk to me about the floor mats I see in the pics: Size, feel, cost, seller, etc.

To which should be added, "buliding codes"

I have an asymmetrical (Mohawk A-7) and do in fact load my 1997 Nissan Kingcab XE D21 Pickup in both directions, without any problem? Despite the high falutin' model name, it is a small pu truck.

Designed/built my own. It has windows. Like another poster here, I highly recommend them. Makes a world of difference. Mine has a sliding door. Recommend that also. No warp, alignment, etc. probs. Best feature of my shed is the gambrel roof, which provides an loft for extra storage. I...

Does a '62 Olds count? My Mohawk A-7 works just fine with it.

Here is mine -

I was in a very similar situation. However, my 2-car garage was built in 1948. It took me 3 contractors to find someone who would do it my way. My way was take off roof, remove one side wall, add bay with scissor trusses for lift, reroof entire structure and then reside entire structure. Did...