Search results

Yes get a lever hoist and sell both the Wyeth Scott and cable hoist and get a proper Trifor hoist.

I have used CRC gasket remover as well

The EPA removed methylene chloride from paint strippers several years back so none are what they use to be. I have decent luck with citris strip or aircraft ultra paint stripper

I’m going to put this right here

Snap-on/mechanic time save lock a socket rails. I cut all mine to size so no wasted space.

I guess it would depends on exactly what you are looking for 7/8 0 offset or 15 degree, reversible or non? If you are looking for a 0 offset 7/8 non reversible snap-on is your only option for made in USA as far as I’m aware. If you want 7/8 15 degree offset reversible. There is no made in the...

Have you looked at vidmar or Rousseau both you can customize to your liking and probably come in around the same price.

I agree with Renegade1Ll a winch is the way to go. But I am a little confused by your explanation. If you want to change the direction of pull to put you next to the tractor simply switch the blocks. You could also get an ascender/descender to pull the rope thru and it will hold it then you...

Good catch I missed that

They are two different tools meant for two different operations. Usually you would use the jigsaw to cut irregular shapes in wood, plastic and metals. Think circles and curves. Can be used for straight cuts also but generally there is usually a better tool to use for straight cuts. Bandsaw...

What capacity do you need? How long of a reach? What is your budget?

Wouldn’t it be cheaper and quicker just to replace the entire sidelite with one that fits your taste/needs

A fortune in deed. About $2500 plus shipping for the 4in another $550 if you want the rotating base

PEC, IGaging on the cheap side. Starrett if you have money to burn.

Best rotator vise is the Swindens then comes the Chas Parker

Carbide burr in a Dremel then use an extractor. Spray the bolt with penetrating oil well in advance.

If you aren’t worried about the surface under them you can use a chisel to cut the head off and push them thru. But honestly the correct size drill bit is usually the easiest method.

Really hard to say without a picture

Threaded backer plate/adapter plate. But why can’t you center the hub or drum on the rotary table and not use a 3 jaw chuck?

Tools are built to a price point most consumers are not willing to spend what it cost to make and design a quality tool.