Search results

My grey low profile i use 5 days out the week had it for about 5 years and i can lift a car but it will slowly go back down after a couple hours

So it's time for a new jack my harbor freight grey low profile jack finally died I was wondering how the new orange jacks compared to the previous generation grey jacks For the orange jacks vs grey jacks Are they built better? Better pumps? etc etc

How does the new orange jack lift compared to the gray jacks? For example if you were to go down on the handle in 1 stroke which jack would be in a higher position?

HI everyone one my girlfriends dad found this and was wondering what the he'll is it lol

I would recommend this http://www.gearwrench.com/gearwrench-81015-1-4-drive-full-polish-locking-flex-head-teardrop-ratchet.html

Which has more has more power the MG725 or the Aircat 1150? Also hows the trigger on the Aircat 1150 can you feather it?

Do you have a store called EASTWOOD around you?

Got a link?

This is what I recommend and use http://www.gearwrench.com/gearwrench-3680d-15-pc-ratcheting-serpentine-belt-tool-set.html

Like this?

Hmm can you gete a pic of how you got it wired?

Hey how did you wire your capillary thermostat?

Ok question how did you ground the rv water heater element?

Did you use a heater?

Yeah I was looking at those also....how many watts do you reccommend for the stick on oil pan heater?

Just a got a 20 gallons parts washer and I'm going to be using water based solvent....and I want to heat up the solution was wondering in anyone used a magnetic engine block heater to heat up their tank and how effective it would be Please reply back thanks

Hi I have a 20 ton air hydraulic shop press and seeing what everyone recommends as far as what size bearing splitter to use to remove the stuck inner race on wheel hubs Please reply back thanks

Bump

Here's a pic

Ok also I just bought a new 145-175 pressure switch...and it shuts off @170 psi...should I adjust it or leave it alone?