Search results

Ended up getting a brand new Lesson 1.5HP 3 phase motor off facebook for $80 bucks!! unfortunately it didnt have a mounting base just holes that treat in the the front case of the motor. So i found a conversion bracket on ebay and paid almost 2x for that than the actual motor :ROFLMAO:I'm still...

I am working on finishing my restoration on a powermatic 1150 some how i misplaced the bearing spacer that goes inside the quill between 2 bearings. I figure i will have a machine shop make another looks very simple to make. I just dont have its measurements. I got the OD obviously since its...

An unrelated question. was going to make a new thread but seems some knowlegable people on here. The press has a 3/4hp 1725 rpm motor. I was wanting to upgrade the motor to either 1HP or 1.5HP. I know its probably unnecessary but why not. As long as its the same rpm and shaft size to fit the...

Yours looks fine to me if the one from clausing press dosent work ill take the pdf. Suprised i cant find one on ebay theres almost everything else on there for the press.

the center to center is about 2-3/4" and the diameter 2-1/4"

im interested what material would it be made from? feel free to email me [email protected]

also picture of it on your press?

What price are we talking and what material?

I was disassembling this drill.press and accidentally crackedthe depth stop yoke assembly.(overlooked the set screw😑 and did too much prying/beating) . I cant seem to find the exact replacement. I see these from many other drill press branda but known look exactly the same. Mainly on mine the...

Price is OBO and SEND ME YOUR TRADES please

Bump price reduction

Brand Spanking new 5hp baldor motor. Still in the box inside the plastic wrap. As brand new as it gets. This motor Retails anywhere from $760-$900 Usually plus Shipping/Tax ect. Here are the specs on the motor and Part #. Asking $490with Free Shipping in the Lower 48. Also have this listed on...

I got it all figured out and wired up. Fired right up! Thanks everyone for all of your input and assistance. No electrician was needed!

Cool. Does the starter have to be grounded? Or can i just run a ground to my pressure switch and run a wire from there to the green ground screw on the motor because i dont see where to ground in the starter assembly. Also, i dont have to run an 8 gauge ground from the breaker box correct...

Ok gotcha. So connect wire 8 and 1 together and run on of the lines from the starter to those and do the same for wires 4 and 5? I think im reading the diagram correct now. Do i need to run a ground from the breaker box to the pressure switch?

Ok i think i have it figured it out. Run the wire from the breaker to the lower screws on the starter and the upper screws go to the Motor. Ya i was missing the heaters i installed it. I attached a picture of my pressure switch i believe i just run the wires from the starter to the first set of...

#8 THHN with a 50amp breaker. Do does the motor not have a ground wire? What are the heater wires and what do i do with them?

So im almost done building my air compressor. All i have left it to wire up the motor, starter, and pressure switch. The motor is a 7.5HP baldor than pulls 32 amps and the Starter is a Sqaure D. So i believe i run wire to the starter then to the pressure switch and from there to the motor...

ok thanks everyone. Whats the best method to get the flywheel on the pump?

Im Putting my compressor together that im building. Im just double checking im putting the flywheel on the correct way. Is picture one correct?