Search results

Bump, to see more garages !!! How does the RaceDeck style flooring hold up to jacks long term ?

I like those !!!!

Great thread !!!

Nice garage !!!! I just put a mini-split in mine, along with doing a DIY insulation job on my west facing garage door. Now when it's 113+ outside, I have a very comfortable 77* garage to work in when needed :) Once I get the engine back into my Z06 and can move it out of the garage, I'm...

Preparing my engine for shipping to my builder :)

When I had my mini-split tested, the vacuum being applied was read as a micron reading. He pulled vacuum for 15 minutes and said anything under 400 was good.....mine was under 360.

LS7 heads are off and going back to West Coast Cylinder Head for inspection before going into another project. Removing short block later this week to ship to builder :)

The manufacture states it doesn't matter which side faces in or out....I prefer the look of the foil face over the white poly side with lettering on it. "Which side of the R-Tech Panels should face inside? Either side of the R-Tech panels can face inside. Generally people prefer to have the...

Started tear down of my LS7 427 in my Corvette Z06

I did the basic install myself, but had an a/c tech come out on site to test the line set, pressure and vacuum test, the release the R419A into the system...at a cost of $260.00. I also had an electrician friend come out and run me a new 20A circuit for this unit....35' run of conduit and 10...

1.5" :beer:

It's probably a good idea to have a tech out to re-adjust the sping :beer:

I recently had a new garage door spring installed, so maybe that's the differnce :thumbup:

I was dying in the garage before, with 110* ambient air and little ventialtion other than a floor fan.

As it's been getting extremely hot again here in Arizona, and I've been doing a significant amount of work on my Corvette in the garage, I finally made the effort to make the garage survivable (and comfortable :) ). First to get tackled was my metal, non insulated garage door on my two car...

EMC120J :thumbup:

I know it's not the norm, but I purchased a new Mirage 12K BTU 110v unit from a local online auction site, and won the bid at $360.00 :) I mounted the air handler, ran the refrigerant, control, and drain lines, cut the opening in the exterior wall, all myself. I then had a HVAC company connect...

Mini-split air handler mounted, exterior wall hole cut, and refrigerate and power lines run. Now if need to get power run from the breaker box to the condenser and the lines all hooked up, pressure tested, and filled.

That looks great !!!! I'm looking at doing a white/light grey marble like coating on mine, to add brightness to the garage when I'm under the car working on it.

LL AV gas would destroy any catalytic converter, if this is going into a street driven car. Unless this is going into an older iron block/head car from the 60's, not sure it would be a good idea.