Search results

I took a slide stop out from another slider and melted and dremeled it down to work as stop for the toolbox drawer. thanks! Now i need to figure out how to get the slider tabs mounting in tightly and flat. I only have about a 2" space to reach in and up to flatten the tabs to the box. . other...

thank you! the issue was the end stop was missing so the smallest part of slider with ball bearings came out the end of the slide . luckily i found all the ball bearings.. I couldnt find an end stop.. not sure what they are called?? the small piece of rubber/ plastic that holds the slider in...

thats a good idea! i will post a photo tomorrow of the space i have ot work with.. i post of the space on 1 side is about 2" wide.. that is the left hand photo. the righthand photo is of the inside- you can see the hole on the left and right side (barely) where the tabs from rail go. i...

I found this "free" toolbox . I was super excited because I need one! i found out one of the drawer slider has issue.. I was going to replace the sliders but then i noticed the current slides are " tab mounted" they must have another name.. as I can't find these anywhere on line.. And there...

wonder if you had any luck finding the plastic end stops? I have a similar need only I need a front end stop. I tried to fashion one using a small screw and a little piece of rubber..but it only partly works. mine is attached to a "plastic" toolbox/work rolling workshop thing I found...