Search results

BUMP

Thanks!

Nope. Just a Square D pressure switch. Don’t remember if it came on the tank or with the pump.

Thanks, everyone!

Nope. SquareD pressure switch. Don’t remember if was on the tank, or came with the compressor pump. Probably contributed to me Wiring in the fused disconnect.

Thanks! No on/off switch on the pressure switch. Just thought that I had to have a separate on/off switch.

Panel is three feet away. What would you recommend for a disconnect or start/stop switch? is the contactor and relay accessible by pulling the cover? Thanks!

Thank you!

No air noise upon shutoff. Don’t know when it blows fuse. Intermittent use.

Thanks, did not know that about the mag starter and fuse, Had the surplus disconnect and used fuses to make it operable. Don’t know about heaters

Thanks for the response! I started it again and upon shutoff, can hear no air release. Check that next. Anybody have specs or diagram on this pump?

Although I’ve been active on the HAMB for 20 years, I cruise over here when time permits. Here’s my problem. I have an older Wayne compressor that has been a work horse for 15 plus years for me. Model 6885-SH, two cylinder, two stage. Used when I got it. It’s running a 5 hp, 240V, single phase...

Looking for a KR Wilson engine adapter A-331 (Model A & B four cylinder) for KRW engine stand. Have a 6000 B-E engine adapter ( flathead six cylinder) to trade if you need one for your collection.

Many thanks!! I already have the V8 and 4 cylinder ones. I have been looking for a base, and ran across this cupcake. Was $200 too much?:D

Thanks! I'll try that. Anyone else able to ID it?

Can't post more than one pic.......

I just got this home, and don't have a clue as to what this adapter is to. Casting is 6000 B-E

Thanks, Charles, for the response. I like the suggestions of the 4 wire run and the size upgrade. I was most concerned with the junction box connections. It sure saves on the wire costs. Anybody else care to chime in or add on? Thanks for the help!

I have 100A service to my detached shop from my 200A house panel which has a breaker for it. The detached shop has a 100A panel with main breaker also. I want to continue 30A, from the 100A panel, 120 feet, on to an additonal detached bldg for lights and recpt. 10/2 (?) on its on breaker...

Came over from the HAMB, so I'll jump in here. I've lurked for awhile and read a lot of opinions and results, so I will try to ask questions that can be answered without a bunch of drama. This is a 28x34 shop, used as a rod building shop, not just a parking garage. 1. What prep does a...