Search results

Check the ID of the roll pin, perhaps you can tap it and pull it out.

perhaps you could use some of this panel for the interior.

I have that engine lifting device and it works. I did taper the edge of the nut to allow it to tilt a little further. I made an adapter plate to attach it to a Gen 2 LT1 intake manifold with 4 M6 bolts.

My preferences start with time zone

I agree, check the oil pressure with a gauge. Then change oil to 10-30, 15-40, 20-50, whatever you decide and see what difference it makes. you are headed into summer so the higher viscosity will not be an issue with cold starts. This will gwt you through the warm weather and maybe further.

The Gearwrench sets, 1/4", 3/8", 1/2" I have all say Made in Taiwan. Ken

Something I have done to make radiator and heater hoses easier to install and remove is wipe a thin film of silicone grease on the ****** and interior of the hose. I use sil-Glide from NAPA. Hose slides on and off and the clamp provides retention and sealing. Ken

For your dowels did you consider adding a knurl to one end to tighten the fit in the table? Ken

That's wht you have the other set of keys in your left hand pocket! Ken

Are you going to get in trouble for importing invasive species attached to the vehicle?�� Ken

I installed a Weil-McLain boiler in 1988 in my house in Chicago. It was a GVxx and I also used the boiler to heat the domestic hot water. Worked fine. I had trouble with the vent piping as it was the concentric pipe in a pipe the for intake and exhaust. In the winter the wind would blow the...

Are you driving that Caprice? Ken

2 x 4 cut to the correct height and plywood will also get the job done. Ken

I used 12 x 12 floor tiles and plywood , been in place 7 years , no problem. Not bolted down. Ken

Pallet rack comes in a variety of depths. I have seen 24", 36", 42", and 48" offered. Ken

I have a 4 post Direct Lift. I have a sliding jack (cheaper than a rolling jack, same function) and a 3 compartment? air bag jack. I use the air bag on the rear axle. I have rear wheel drive vehicles. I have had all wheels off using this setup. Ken

I think you are refering to this kind of tool. http://www.beadform.com/ I have one and it works qiute well. Ken

I have a Direct Lift 4 post that is not bolted down. I have used it for over 3 years this way with no problems. I usually have a vehicle on it with another underneath. Ken

Can you reverse the rpm signal also?

Anyone have any experience with an Integrity INT9 lift. Appears to be several years old manufactured by Forward Manufacturing. Phone number on label is 800 423-1722 which is the current number for Forward Manufacturing in Madison, IN. They are a Dover company which also owns Rotary. All the...