To avoid these ads, REGISTER NOW!

Finished project garage: photos of current condition

nytehawk

Well-known member
Joined
Jun 29, 2008
Messages
57
Location
Southern CA
Hey guys, I've really enjoyed this website -- and more importantly the wonderful people who make it what it is! Your responses to my last post encouraged me to drag out the mop, do a little tidying, and take another series of photos showing the most current condition of my favorite room in our house. Here are a few highlights, starting with a panoramic series.

(Like all true projects, this one is still a work-in-progress, but the primary effort started with epoxying the floor in late July 2005 and finished with cabinet installation in August 2006.)



Front wall with workbench, toolbox, and compressor. Door on left goes into house; door on right goes outside to yard.
Garage052.jpg


Panning around to the left wall.
Garage071.jpg


Left wall and garage door.
Garage058.jpg


Garage door: insulated with pop-in foam panels.
Garage060.jpg


Continuing around: garage door and right wall. Perhaps someday I'll get some cabinets to hide all that stuff on the shelves...
Garage061.jpg


Completing the panoramic: back to the front wall.
Garage064.jpg


Slightly closer view of workbench area.
Garage054.jpg


Close-up of toolbox and compressor.
Garage066.jpg


Proof of daily use as a garage.
Garage101.jpg


My pre-mid-life-crisis toy and future project car in the garage. (Note: yellow is not my favorite color; it just happens to look good on some things. In this case, the yellow in the garage preceded the yellow car by about two years.)
Garage088.jpg
 
To avoid these ads, REGISTER NOW!

SWA Guy

Well-known member
Joined
Dec 12, 2006
Messages
111
Location
Sacramento, CA
Great looking space! I like the stripes and will probably add something like that to my shop.

Which epoxy did you go with? How long has it been down? Are you happy with it, or any complaints?

Thanks,
Guy

www.737guy.com
 
OP
N

nytehawk

Well-known member
Joined
Jun 29, 2008
Messages
57
Location
Southern CA
Great looking space! I like the stripes and will probably add something like that to my shop.

Which epoxy did you go with? How long has it been down? Are you happy with it, or any complaints?

Thanks,
Guy

www.737guy.com

Guy, I actually used the standard water-based EpoxyShield by Rustoleum. I applied it about 3 years ago and have been very happy with it thus far. I wrote up a whole post containing great detail on my experience with this product and you can read it at http://www.garagejournal.com/forum/showthread.php?t=19599

Nice setup! What kind of cabinets are those?


Chris

Yes x2, what cabinets? I tried to zoom in to read the logo.

Tim

No problem Chris and Tim. I purchased the cabinets through Costco.com; they were mfg'ed by O'Sullivan at the time and cost me $70 each including tax & shipping. More details on these cabinets are on page 2 of the following thread: http://www.garagejournal.com/forum/showthread.php?t=19544&page=2
 

iamthor

Member
Joined
Feb 3, 2006
Messages
6
Location
San Jose, CA
I like how the McLaren picture matches the yellow stripe and the Viper picture matches the blue hose reel. :bounce:

Just poking fun - the shop looks great.
 

Garyl53

Active member
Joined
Oct 25, 2009
Messages
44
Location
Colorado
Hi,
Admiring your garage, but was wondering how you insulated your door with the "pop-in" panels. Did you just cut the panels yourself or did you use a kit? Also how did you attach the panels to the garage door?
I really like the clean and bright look!
Gary
 

Jack Olsen

Super Moderator
Staff member
Joined
Mar 22, 2009
Messages
6,678
Location
Los Angeles
Garage052.jpg


Super clean.

In your shoes, I'd be tempted to replace those black cords on the ceiling lights with white ones, just to finish it off.

I might even paint the vise. :)
 

Motofixxer

Well-known member
Joined
Oct 10, 2009
Messages
681
Not to knock your complete job, but I would paint the header board above the garage door the same grey wall color. It just kinda jumps out and don't match anything being a raw color with everything else being finished. I also agree with the white light cords. But in general it looks great.
 

E46M3

Well-known member
Joined
Jan 5, 2007
Messages
176
Location
Northeast, Upstate New York
nytehawk,

Turned out great. I actually understand the yellow ladder, sawhorse, level, shovel handle, exstension cord thing. Continuity of color.
I also appreciate the door matt - as it is likely intended for one to wipe ones feet when entering the garage from the house.
Nice job.

Cheers,
E46M3
 
To avoid these ads, REGISTER NOW!

thomask

Well-known member
Joined
May 28, 2009
Messages
354
Location
Sunshine State
nytehawk:

Great clean looking build. Nice paint scheme.:thumbup:

I would have to be wearing a good sunscreen with that much light in my old garage.:cool:
 

Spaggs

Well-known member
Joined
Apr 25, 2009
Messages
61
Location
*******, GA
Job well done! Very bright. It looks like you can actually see what your doing. Color scheme is good also. Not over done.

Again, well done.:beer:

Spaggs
 
OP
N

nytehawk

Well-known member
Joined
Jun 29, 2008
Messages
57
Location
Southern CA
Apologies to all for abandoning this thread for so long, and for the lack of response to your replies. I think I'd better check my email settings for notifications when replies are made to this thread!

Answers to a few of the prior responders' questions (in no particular order):
  • The workbench and wall cabinets were purchased from Costco.com, but that was a few years ago and Costco no longer carries them (at least not the exact same ones). I've been very pleased with the workbench. The cabinets are...okay. They look decent but they weren't too expensive (which was good) but you also get what you pay for. They're holding up alright though. More info on them in this thread. For those seeking a similar workbench, McMaster-Carr appears to have a good selection of components from which you can build your own. I've ordered numerous other items from them in years past and have been very satisfied.
  • In retrospect, I agree with the comments that I should have painted the header beam over the garage door. Perhaps someday I will when I happen to have that color paint opened up for other touch-ups...
  • Good suggestion on replacing the black cords on the fluorescent overhead lights with white cords, but that's a little more effort than I'd care to invest at this point. The black cords carry electricity just fine, and I really don't spend much time staring at the garage ceiling anyway. :*)
  • I've been extremely pleased with how well the floor epoxy has held up. (See details in this thread.) Hard to believe that my wife and I epoxied the floor nearly 8 years ago now, and it hasn't peeled up or flaked at all! Sure, it has a couple spots where tools were dropped on it, but those haven't spread. Just this past November I pulled the cars out, mopped the floor, and we hosted Thanksgiving dinner for a bunch of extended family in the garage!
  • No complaints about the Kobalt air compressor (which doesn't get used all that frequently -- shame, shame, I know...) other than it seeps oil from the drain port plug. I should probably use the opportunity to change its oil and apply a single wrap of Teflon pipe sealant tape when I replace the plug.
  • The pop-in insulating panels for the garage door were a kit that I purchased from Home Depot. They're just white styrofoam, but covered with a textured white plastic that protects them from dents/dings and permits cleaning.
  • Someone commented about painting the vise. Actually, I should replace it with another one as the one I bought has never worked quite right. I'll get around to it eventually, but there are other priorities for now.

And I'll add a couple more photos below. First image shows the current condition of the workbench area -- now with a matching black refrigerator and all-metal stools (purchased from Costco a couple years ago). The second image is one that I took on the day that the good folks from Garage Style Magazine visited to photograph my garage in preparation for a 3-page article entitled A Tidy Two-Car which appeared in their Spring 2010 issue.

IMG_1088Small.jpg


IMG_3019Small.jpg
 
Last edited:

Dan in Pasadena

Well-known member
Joined
Feb 18, 2009
Messages
13,110
Location
Pasadena, CA

Using the yellow stripe is outstanding with the white over gray color scheme. The overall look of your space is great.

NOT criticizing but I agree with Jack that the cords oughta be white - but don't replace them. Just use plastic paint - no one's ever gonna touch them. It ought to hold up fine. Of course unplug them, then wipe down with lacquer thinner. Easy peasy.

Besides painting the vise black, I'd say paint the small fridge black too and maybe add some kind of aluminum to mimmick the tool box drawers. Kudos on a very nice job.
 
OP
N

nytehawk

Well-known member
Joined
Jun 29, 2008
Messages
57
Location
Southern CA
Replaced the white fridge with a black one 2-3 years ago. See more recent image posted above. Good suggestion on simply painting the overhead light cords; next time I have them down for cleaning...
 

55cadillacking

Well-known member
Joined
Apr 26, 2012
Messages
1,959
Location
Calgary
Personally, the black cords look fine to me. The photos you posted show them to be consistent in length and I think they add a little bit of an industrial touch. Your garage is pristine and I'm glad this thread is back in action. Thanks for sharing!
 

mwbailey

Well-known member
Joined
Jun 30, 2012
Messages
821
Location
Rock Hill, SC
nytehawk, Maybe this is paying too much attention to the color scheme, but I have to ask about the air hose colors -- did you get one for "clean" air and one for air pre-oiled for tools? Whether or not, I like that approach; I think I'll use it -- besides, I'm not worrying quite so much as to whether my tool handles match my vise as others might! But I do like the white trash can liner better than the red one. . . . Keep it looking good.

Or maybe it's filtered air versus not. . . .
 
Last edited:

dubber

Well-known member
Joined
Dec 31, 2012
Messages
5,326
Location
Canada's Capital
I had thought i previously commented on your space but i guess i'm getting old haha. Really like what you have done, i actually have the same overhead lights and i love them.

Congrats on the photo spread!
 

Kevin54

MEMBER EMERITUS
Joined
Jan 12, 2005
Messages
29,341
Location
Urbana, Ohio
Garage052.jpg


Super clean.

In your shoes, I'd be tempted to replace those black cords on the ceiling lights with white ones, just to finish it off.

I might even paint the vise. :)

:lol: That was my first thought too. Everything in the garage looks fantastic other than the black cords.

I'd have to change them or run conduit from the center plug and mount a box each way above the lights.

But that's minor. I wish my garage was half that clean. Nice job for sure :thumbup::thumbup:
 

HSpencer

ALLIANCE MEMBER
Joined
Nov 28, 2010
Messages
2,854
Location
South Central US
This garage is very tastefully done. It has excellent organization, and shows careful planning. I really like the room available for the vehicles to park in it. My opinion is simply this:
WOW, it looks great in every way!!!
 

lmb

Well-known member
Joined
Feb 13, 2013
Messages
164
Location
United Kingdom
Apologies to all for abandoning this thread for so long, and for the lack of response to your replies. I think I'd better check my email settings for notifications when replies are made to this thread!

Welcome back. Glad that the thread was resurrected as I'm fairly new around here and probably never would have got around to seeing it otherwise. It looks great!
 
OP
N

nytehawk

Well-known member
Joined
Jun 29, 2008
Messages
57
Location
Southern CA
nytehawk, Maybe this is paying too much attention to the color scheme, but I have to ask about the air hose colors -- did you get one for "clean" air and one for air pre-oiled for tools? Whether or not, I like that approach; I think I'll use it -- besides, I'm not worrying quite so much as to whether my tool handles match my vise as others might! But I do like the white trash can liner better than the red one. . . . Keep it looking good.

Or maybe it's filtered air versus not. . . .

You got it: blue hose is filtered & regulated for air tools, while the orange hose is unfiltered & unregulated (for filling tires, whatever). I used to have the blue hose on a filter/regulator/lubricator (FRL) unit, but the lubricator part was too messy so I replaced it with a smaller and simpler FR unit.

Funny you mention the trash can liner, whose color actually depends on whatever plastic bags I receive from Walmart or the grocery store that week!
 

Derrickwade

Well-known member
Joined
Jun 16, 2012
Messages
612
Location
Illinois
As I was scrolling down through the pics, I was thinking to myself "I bet he's got a yellow car to park in there" and sure enough! Haha. Looks awesome. Nice job!
 
To avoid these ads, REGISTER NOW!
Top Bottom