mheiss5555
New member
- Joined
- May 12, 2017
- Messages
- 2
Greetings!
I have a 102.05600 craftsman jointer with a shaft that has been "grooved" on the cutterhead shaft. Not aware if the original build would have used this shaht as it does not have a key groove to hold the pulley in position.
Asking for assistance on what measures I could take to remedy the issue, there is wobble and play in the pulley while in operation.
Mike H.
I have a 102.05600 craftsman jointer with a shaft that has been "grooved" on the cutterhead shaft. Not aware if the original build would have used this shaht as it does not have a key groove to hold the pulley in position.
Asking for assistance on what measures I could take to remedy the issue, there is wobble and play in the pulley while in operation.
Mike H.
