11/16 deep offset

[BoonDockSaint]

Hi All!
I've been looking around for an 11/16 offset box wrench (about 70degree offset) I've found a few online but I"m really looking for something old or unique. I use this for motorcycle clutch adjustments. Any suggestions other than taking a torch to an existing wrench? If someone has something old or unique, I have some large snap-on short offset box wrenches I would trade one of them for. So far, google has turned up only generic stuff.

Thanks!

 

[jim faston]

I like the old Indestro offset box wrenches. I see them at the fleas frequently for cheap.

 

[PJNJ]

Not old but unique -
http://www.zoro.com/facom-socket-wr...gclid=CMGgiZPz5MkCFYQXHwodTIINWg&gclsrc=aw.ds

Not old or unique for the following -

http://www.ebay.com/itm/Snap-On-5-8...:g:96kAAOSwfZ1WYPGQ&item=262191796995&vxp=mtr


http://www.craftsman.com/craftsman-...rd-full-polish-12/p-00944349000P?TecPara=173_

 

[BoonDockSaint]

Not old but unique -
http://www.zoro.com/facom-socket-wr...gclid=CMGgiZPz5MkCFYQXHwodTIINWg&gclsrc=aw.ds

Not old or unique for the following -

http://www.ebay.com/itm/Snap-On-5-8...:g:96kAAOSwfZ1WYPGQ&item=262191796995&vxp=mtr


http://www.craftsman.com/craftsman-...rd-full-polish-12/p-00944349000P?TecPara=173_

Those first one's are cool but I have to get an allen in the center of the wrench at the same time. I don't know why I never think of ebay, I just bid on that wrench, Thanks!

Happy Motoring!

 

[PJNJ]

Just so you know the facoms are open on the right angle end for bolt pass-through. Here's a link to Toolguyd for a review and photos. I wish I had the extra money right now to buy them (though I probably would never use them anyway).

http://toolguyd.com/facom-angled-socket-wrench-review/

 

[ttpete]

Personally, I'd go over to the new and used tool store near me and pick up a decent used wrench and heat and bend it to exactly what's needed for that job. I do that quite a bit. It's a lot quicker and easier than trying to find something that probably wouldn't work as well.

 

[toddacimer]

I have a Snap-on XSO-2226 which is a 60 degree deep offset 11/16-13/16 wrench. If you're interested shoot me a message. It has the previous owners initials in it.