1942 Bridgeport

[Nelson58]

Still looking for an M head to attach to a small horizontal. Not easy finding a good one.

 

[bisley45]

AWESOME!! Thank you for the link! I see in this picture it looks like you are missing the fine feed wheel too? I'm only going by the manual for reference that one should be there, mine does not have one and I wondered if I needed it

Yes they are unatanium from what littlie research I have done I am going to fab one up just in case I need to do some boring. Nine does yours have the large hand wheel that rotates the ram ? Mine was MIA and would love the dim of it when you get the time.

 

[Maui]

I have an M head that came off of a full size horizontal mill. I'm still trying to figure out how to attach it to my Vernon No 0 horizontal mill (if I can).

Maui

 

[nine4gmc]

Yes they are unatanium from what littlie research I have done I am going to fab one up just in case I need to do some boring. Nine does yours have the large hand wheel that rotates the ram ? Mine was MIA and would love the dim of it when you get the time.

Mine does have the ram wheel, it's 8" diameter with a handle screwed on and a square broached hole.

 

[bisley45]

Mine does have the ram wheel, it's 8" diameter with a handle screwed on and a square broached hole.

Thanks Nine just what I needed hard to tell the dia from a pic[emoji106]

Sent from my XT907 using Tapatalk

 

[Dennis Leigh Henry]

Just catching up on this thread.. the finished mill looks great!!