jfk92
Well-known member
Hello,
I'm about to re-assemble the subject drill - I have the spindle and quill fitted with new bearings and together with the collar & pin as well as the thread protector nut. Any tips for any specific parts are most appreciated - I've degreased as much as I care to and washed up the rest of the cast pieces - but could use suggestions around areas you may know of that can be a little frustrating. Also - I have a generic white NLGI2 Lithium grease to use - so - ex. greasing the quill teeth/pinion shaft teeth and any surfaces they ride in etc. Thanks in advance.
John
I'm about to re-assemble the subject drill - I have the spindle and quill fitted with new bearings and together with the collar & pin as well as the thread protector nut. Any tips for any specific parts are most appreciated - I've degreased as much as I care to and washed up the rest of the cast pieces - but could use suggestions around areas you may know of that can be a little frustrating. Also - I have a generic white NLGI2 Lithium grease to use - so - ex. greasing the quill teeth/pinion shaft teeth and any surfaces they ride in etc. Thanks in advance.
John