2 inch LB question

[billd6]

What's the best way to transition conduit from a 2" LB straight up to a sub panel mounted between 2 x 4 studs?


Sent from my iPhone using Tapatalk

 

[pattenp]

Use another LB.

 

[tfi racing]

If the heights work out,stub it into the back of the panel.

 

[billd6]

The 2nd LB sticks out past the width of the wall studs


Sent from my iPhone using Tapatalk

 

[billd6]

The stub is a great idea but the exterior LB is already installed near ground level. Any other ideas?


Sent from my iPhone using Tapatalk

 

[Eriehunter]

PVC junction box?

 

[Aceman]

The 2nd LB sticks out past the width of the wall studs


Sent from my iPhone using Tapatalk

You can't bury an LB cover behind sheetrock anyway, it has to be accessible without removing the building finish to get to it.

Two ways:

1. Run up the exterior wall and LB into the back of the panel. Simple and clean.

2. LB from outside into a j-box down low inside, with the cover of the box coming through the sheetrock and ****** out of it up into the panel.

 

[pattenp]

The 2nd LB sticks out past the width of the wall studs


Sent from my iPhone using Tapatalk

Just as Aceman said, you can't cover a LB or j-box. I used two 2" LB's back to back and cut the sheet rock around the LB cover and left it exposed.