2-Post Lift Decision

[thejudges69]

I'm actually delivering just east on Hudson, NH tomorrow I may just dart over to Greg Smith and look at an atlas in person.

 

[KaiserJeep]

We installed the lift yesterday. Had a couple of friends drop by to help move the posts into position. I did have to take down one of my ceiling fans, but it will be re-positioned later this week.

 

[493 scamp]

My Atlas 9OHSS for cars and light trucks. Did you get yours up yet? Happy? I really wanted something closer to our Rotary at work because of flip up pads and asymmetric design,but this fit my budget.

 

[Flipper88]

Put up the lift over the weekend. I would say took me and a buddy 5 hours from start to finish to get it up and running. Really happy with it so far! Don’t mind the mess in the picture… I have the lift angled a bit because of the configuration of the door being in the middle of my shop. This way there is still enough room to store a car to the left of the lift and be able to use it.

Very happy with Greg Smith Equipment. I thought I was missing the truck adapters but they were wrapped and in behind the cylinders for shipping. They assured me they were there and that’s exactly where they were. They said if I didn’t locate them they would ship me a new set right away. As far as the quality of lift time will tell how it holds up. But for the money I think it will do just fine. Put the little car on it and it performed flawlessly.

 

[ymurf]

Put up the lift over the weekend. I would say took me and a buddy 5 hours from start to finish to get it up and running. Really happy with it so far! Don’t mind the mess in the picture… I have the lift angled a bit because of the configuration of the door being in the middle of my shop. This way there is still enough room to store a car to the left of the lift and be able to use it.

Very happy with Greg Smith Equipment. I thought I was missing the truck adapters but they were wrapped and in behind the cylinders for shipping. They assured me they were there and that’s exactly where they were. They said if I didn’t locate them they would ship me a new set right away. As far as the quality of lift time will tell how it holds up. But for the money I think it will do just fine. Put the little car on it and it performed flawlessly.

If you don't mind me asking,How much did it cost you?

 

[Flipper88]

If you don't mind me asking,How much did it cost you?

It was $1795 out the door. No tax in Oregon and I picked it up so no shipping. I opted for the BP9000 because it has wider drive through space. And without the adapters the arms lift to 6’2” which is plenty high for me at 6’1” tall.


http://www.gregsmithequipment.com/#Atlas-BP9000

 

[Nathan Cox]

I bought the 9KOH from GS a little over a year ago and I could not be happier with the lift. I had it delivered and installed for $600.

Do all of the locations offer installation? For that price I would be all over it.

I am in the process of ordering one and was trying to figure out I would unload it off the truck and be able to move it around. Would much rather have them do it turn key.

 

[Flipper88]

Lift up and ready to rock!

 

[Mr. Roboto]

Thanks for all the pictures...I have a BP9000 on order and am pretty excited to get it in an installed!