2' x 8' x 3/4" Melamine Source

[CHuDWah]

Anybody know of a source for 2' x 8' x 3/4" white melamine? I need some for cabinet shelves. Home Depot has 2' x 4' which is too short and 4' x 8' which is too wide - I could cut it down but that would waste half of it.

 

[Voi]

I have purchased bull nosed shelving in that size at Menards. It's far from the best melamine I've purchased but it holds up okay.

I have also bought partial sheets from cabinet shops & even have had them run it through their edge bander.

Not sure if Menards still carries that product or if you have one in your area but if you do I'd start there.

 

[Bolson32]

I have purchased bull nosed shelving in that size at Menards. It's far from the best melamine I've purchased but it holds up okay.

I have also bought partial sheets from cabinet shops & even have had them run it through their edge bander.

Not sure if Menards still carries that product or if you have one in your area but if you do I'd start there.

I think it's actually 23 1/2" but yea. I was going to suggest the same thing.

Sent from my SM-G965U using Tapatalk

 

[CHuDWah]

I have purchased bull nosed shelving in that size at Menards. It's far from the best melamine I've purchased but it holds up okay.

I have also bought partial sheets from cabinet shops & even have had them run it through their edge bander.

Not sure if Menards still carries that product or if you have one in your area but if you do I'd start there.

I think it's actually 23 1/2" but yea. I was going to suggest the same thing.

Sent from my SM-G965U using Tapatalk

Sadly, no Menards in Florida. Thanx anyway.

 

[Lightning rod]

https://www.lowes.com/pd/Melamine-Board-Actual-0-75-in-x-49-in-x-8-08-ft/3605066

Have them cut it down the middle
You should get two pieces out of it

I have done this before

Ironed on melamine edge when needed or

In the garage, i use pine strips to finish the cut edges