2013 edge cooler line tool! Need help!

[bodyguy16]

Hi all,

Im working on a 2013 ford edge front end collision at work and cant find a trans cooler line disconnect tool that works! Went throught about 10 of them, none were good......ended up just cutting the small piece of condensor to remove and replace front end but i need to properly remove the small pice of pipe left over. while searching online i found some otc ford tools and some "master kits" also saw the ford tool on alldata. Any ford techs know of any "aftermarket" tools that work?

Thanks everyone.

Sent from my SM-G903W using Tapatalk

 

[Mastermind]

I have the maroon ones that are supposed to be for fords, has a little step in it compared to a normal disconnect

 

[bodyguy16]

I have the maroon ones that are supposed to be for fords, has a little step in it compared to a normal disconnect

Thats what i need, would you happen to remember who manufactures it? # etc ?

Thanks

Sent from my SM-G903W using Tapatalk

 

[mcmtech]

I think the lisle 39960 is the one you want

 

[jgschroeder99]

From the Ford workshop manual, here is the tool that you need.

https://www.amazon.com/Otc-307-569-Disconnect-Tool-Line/dp/B007TN18Z2

 

[bodyguy16]

From the Ford workshop manual, here is the tool that you need.

https://www.amazon.com/dp/B007TN18Z2/?tag=atomicindus08-20

Thx ill call my indy guy and ask to deliver.

Sent from my SM-G903W using Tapatalk

 

[shockwave]

They also have assenmacher version which is aluminum too that are nice which I use

 

[jgschroeder99]

Thx ill call my indy guy and ask to deliver.

Sent from my SM-G903W using Tapatalk

No problem. If you want, I can send you a pdf file containing the removal/reinstall procedures from the workshop manual, also. The file is too large to attach on a GJ post, but I could email it to you directly.

 

[bodyguy16]

Pm sent thx

Sent from my SM-G903W using Tapatalk

 

[bodyguy16]

They also have assenmacher version which is aluminum too that are nice which I use

From the Ford workshop manual, here is the tool that you need.

https://www.amazon.com/dp/B007TN18Z2/?tag=atomicindus08-20

Finally got it done thanks guys, the assenmacher was the only one available, it was the copper one, anyways worked like a charm.

Sent from my SM-G903W using Tapatalk

 

[amlv20]

Finally got it done thanks guys, the assenmacher was the only one available, it was the copper one, anyways worked like a charm.

Sent from my SM-G903W using Tapatalk

Good I wasn't sure if you got my pm last night and that was the link I sent you if you didn't get it.