Hey
I have an old 3/4 inch Chicago Pneumatic impact that goes by the model number CP-872. When I type that number into a search I wind up with Die Grinders.
The impact also says Pacesetter. Anybody know anything about it. I have a torque tester and this reads about 750 ft pds. I usually get a little better reading from a CP772. I'm using about 130 PSI.
thanks
Ray
I have an old 3/4 inch Chicago Pneumatic impact that goes by the model number CP-872. When I type that number into a search I wind up with Die Grinders.
The impact also says Pacesetter. Anybody know anything about it. I have a torque tester and this reads about 750 ft pds. I usually get a little better reading from a CP772. I'm using about 130 PSI.
thanks
Ray