36x72 morton barn build

[Briggs]

Absoulutely beautiful. That is a huge door too, love the design in the walkway.

"A mans project is never complete, neither is a good husbands will to please his wife."

Keep the pictures coming good sir...

 

[TRWTOW]

Looks great....following to see what kind of heater you go with, I'm in the same boat.

Shaun

i just seen yours wow nice. still havent decided on heat, radiant tube or hangin forced heat. winters in the air here in michigan 45 and rain now. need to finish drivway very soon

 

[TRWTOW]

driveway back in progress ran out of daylight ill get some more in mornin

 

[TRWTOW]

cement driveway done tuesday and wed heres somr piks came out great 93 ft long 43 wide in turnaround 36 wide in front of barn 24 wide out by road

 

[sundevil64]

It sounds like Morton does a good job . I am considering them for a 40x50 build. How thick did you go with the concrete inside? Are there plans for a lift? I love the big turnaround area.

 

[TRWTOW]

thanks inside 5 inches w lots of rod not sure on lift yet little over budget.

 

[TRWTOW]

gas electric finally done been waiting since july 19

 

[flybefree]

TRWTOW,

Got a quote for a radiant tube heater, installed complete for the 64 x 42 shop right at $3100 from a solid local guy. Going to check around with a few other folks, but given the cost of the systems I have looked at $1900ish just for the tubes that may be a good quote.

FYI

Shaun

 

[armstrr]

I just started a thread on my build (which used a bit of concrete as well). I am on the Candian side by Port Huron, Mi. Do you mind me asking what a yard of concrete (standard 2500psi mix..or whatever) is worth? I made a couple calls to see about importing it because I heard the price was a lot lower in the US.

Thx!

 

[CamarosRus]

Looking for a shop (pole bldg) contractor in South King county area, Wash State.......

 

[TRWTOW]

project back on. got my furnace 150000 btu made in america. got a few temp lites rigged up essentials g door opener bathroom lites water heater and electric furnace. have a lift comin next week will install everything permanent and in conduit then

 

[TRWTOW]

dont laugh here my temp wiring

 

[sundevil64]

I love the alum trailer. What is that 20'?

 

[TRWTOW]

I love the alum trailer. What is that 20'?

yes 20ft featherlite

 

[TRWTOW]

furnace is in lites go up dec 26 cant wait

 

[CamarosRus]

Please show a few pictures of wood framing that sheetrock and ceiling attaches too ????

 

[TRWTOW]

started hangin lite and plugs lots of conduit to bend

 

[TRWTOW]

fixtures are t8 6 bulb wow lites come along way since i built last barn. also puttin up 3 fans. thanks for lookin terry

 

[pontifex4]

fixtures are t8 6 bulb wow lites come along way since i built last barn. also puttin up 3 fans. thanks for lookin terry

Nice fans -- what are they, and how big? I really like the driveway, too.

 

[TRWTOW]

update built a closet to match bathroom building benches in between 20 ft maple tops got here yest so nice cabinets be here wednesday been a great project. building is air tite highest gas electric bill has been 60 bucks

 

[TRWTOW]

built a extra bench while i was savin up to build the other one
scored 4 ac guide bulb cabinets off ebay and already had the borgwarner cabinets. thanks for lookin terry

 

[BigMoneySteve]

Nice job. I just had a 30x50 Morton put up at my place. I wish I had the inside finished like you did though. Any tips for me? Would you have done the walls and insulation any differently?

 

[TRWTOW]

Nice job. I just had a 30x50 Morton put up at my place. I wish I had the inside finished like you did though. Any tips for me? Would you have done the walls and insulation any differently?

no.. but i will say the steel kinda of a pain to hang signs and stuff but its clean and bright

 

[BigMoneySteve]

I hear ya. I'm at the point where I am trying to decide what to use to cover the walls. I think I will do like you with the horizontal nailers. I'm leaning towards just using plywood on the walls. decisions...decisions...

 

[TRWTOW]

cabinets done today heres some pics

 

[AMCguy]

Wow! I am very impressed.

What a delight it must be to step out your back door in the morning, with a cup of coffee in your hand and walk down that pathway.

 

[NASMAN]

Very nice, inside and out.

 

[hippie2cams]

super!!! very good looking build

 

[Kels]

Did you have anything between the metal and fiberglass insulation on the sides? I couldn't tell from the photos.

 

[Dr Dave]

Very nice building, I like your bench and back wall.

Dave

 

[MSD Shop]

I am in awe of the wood trim and workbenches, wow, just awesome!

 

[TRWTOW]

thanks for all the responses ill get out there and get some more pics soon

 

[J-man67]

Wow, that is awesome! Great work!

Sent from my SAMSUNG-SGH-I747 using Tapatalk

 

[mrycar]

Any more recent pictures? Good to see another Michigan Morton garage.