4 post lift

[pcoffroad]

I'm sure this has been discussed a million times. The story of my life, I'm an inch to short. Need to add an inch of height under the columns legs of 4 post in order to get my sxs under. Yes I could look for 1" plate, however was wonder if anyone would have a suggestion on different or other ways to achieve this? I am going to bolt it to the floor.

 

[LXCam]

Washers and dry pack it.

 

[ovilla]

Lower your ramps all the way and then go around to each corner and raise the tabs and tighten the cables accordingly until they’re an inch or more higher. That will give you the height you need.


Sent from my iPad using Tapatalk