You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
6 inch dual Phillips #1 & #2 driver bit?
- Thread starter JesseWV
- Start date
MFolks
Well-known member
Maybe at Home Depot,they sell the Husky brand with removable bits,that store in the shaft #1,#2 and two sizes of flat blades. Researching through my tool bag, If found # 628-375 for the part number.
MFolks
Well-known member
It's under $5, and still available.
TigerDude
Well-known member
PB Swiss roll-up kits seem to have them, but not sold individually.
http://www.shop.pbtools.us/53-Series-Tool-Sets_c462.htm
http://www.shop.pbtools.us/53-Series-Tool-Sets_c462.htm
I have one of those for manual use, but I'm actually looking for a driver to use in a screw gun. I work in data centers and quickly need to switch between #1 and #2 bits. Having it on one bit that I can just flip around would save a lot of time.
Maybe at Home Depot,they sell the Husky brand with removable bits,that store in the shaft #1,#2 and two sizes of flat blades. Researching through my tool bag, If found # 628-375 for the part number.
You had me all excited until I zoomed in and noticed they have it set up with a Phillips on one end and a comparable sized flat on the other. I need PH#1 and PH#2 all on the same 6 inch bit.
I want something like the Makita-B-39637 but with a PH#1 on the other end.
I want something like the Makita-B-39637 but with a PH#1 on the other end.
PB Swiss roll-up kits seem to have them, but not sold individually.
http://www.shop.pbtools.us/53-Series-Tool-Sets_c462.htm