7/16" deep swivel socket on 1/4" hex shank?

[Ign]

Looking for an integrated, one-piece 7/16" deep swivel socket on a 1/4" hex shank.

Anyone know if it exists?

The point here is to have no adapters, nothing that can pull apart.

Also the question isn't how to build one, it is if one already exists on the market.

 

[General Geoff]

Looking for an integrated, one-piece 7/16" deep swivel socket on a 1/4" hex shank.

Anyone know if it exists?

The point here is to have no adapters, nothing that can pull apart.

swivel socket + square drive to 1/4" hex adapter + jb weld

 

[mikebaker1129]

Apex?

 

[Ign]

The idea is also as short as reasonably possible.

Stacking adapters on swivels or swivels on adapters increases Z space vs a unit manufactured as one.

 

[decableguy2000]

These maybe
https://www.zoro.com/dewalt-nutsetter-set-14-516-38-716-hex-dwpvtdrv/i/G7637822/feature-product?gclid=EAIaIQobChMIsu7hnIT04gIVDo3ICh2FCg7XEAQYAiABEgIYlPD_BwE

 

[Ign]

These maybe
https://www.zoro.com/dewalt-nutsetter-set-14-516-38-716-hex-dwpvtdrv/i/G7637822/feature-product?gclid=EAIaIQobChMIsu7hnIT04gIVDo3ICh2FCg7XEAQYAiABEgIYlPD_BwE

Ok yeah this might work, thank you!!
https://www.homedepot.com/p/DEWALT-...RCH=REC-_-rv_homepage_rr-_-NA-_-202279618-_-N

 

[Ign]

ah but I see the Dewalts are just a nutsetter so they're not deep, just enough to hold the head of a screw/bolt (the Amazon questions confirm this)

 

[MattT]

The point here is to have no adapters, nothing that can pull apart.

A 1/4" hex to square with a pin retainer will be very difficult to pull apart. Apex should make those.

If that isn't good enough weld the adapter to the socket.