90* sink supply hose?

[nissan_crawler]

Do these exist? i need one badly. I have a sink like this, and the fittings point towards the wall, so there's very little room. Even with 90* fittings, I may have to put a slit in the sheetrock for the first part of the hose.

Like this (this is for a washing machine).

 

[kvom]

I haven't seen supply hoses like that. One solution might be to build a square frame to mount between the wall and the sink to give enough relief.

 

[tbob]

We sell about 15-20 of these sinks a month at work. Use a 3/4" to 1/2" BRASS reducing elbow right off the back of the faucet. Attach a 1/2" male to 3/8 compression fitting to get to your flex water supply lines. You'll have room.
Terry

 

[PAToyota]

Use a 90º elbow first and then connect the hose up to that?

 

[nissan_crawler]

thanks for the help guys, I'll go with a fip x mpt street ell if I can, and if not, I'll sweat together copper to do it, depending on what's available here.