To avoid these ads, REGISTER NOW!

A Question and an introduction...

airbrushguy

Well-known member
Joined
Nov 24, 2011
Messages
55
Hi,
Like the site, been around cars all my life, antiques, resto-mods, hotrods vettes and daily drivers.
My dad had a service station all my young years until I was 27. Loved the idea of coming in any time and putting my cars on the lifts to check anything out. Always been a nut about detailing and loved the fact that I could wax, clean and check everything while it was on the lift.
Fast forward to a house, family and built my dream garage about 20 years ago ( 40 x 26 with full attic, heat, and AC). Didn't have money for lift because they were not as cheap as they are today, and since I built it with a steel I-beam to eliminate poles, I now would have a tough time altering to cut beam and open up ceiling to accept a lift.
I've read about Maxjax and mid-rise lifts and feel this is how I'd like to go but I have concerns...I have a variety of cars from Corvettes to hotrods that are relatively small but also have a 1939 Buick sedan, '71 C10 Pickup as well as family cars.
How much size and weight can these lifts handle? What is the ultimate floor space I need?
My other alternative is to mount a full 2 or 4 post lift outside in front of one of my bays. Do they make a lift that could handle New Jersey weather?
Long and lots of questions, hopefully my future posts will be shorter, thanks.
 
To avoid these ads, REGISTER NOW!

zkling

Well-known member
Joined
Jan 23, 2007
Messages
16,939
Hi, welcome to GJ. :beer:

Not to be an a$$ off the bat, but did you even look for 30 seconds on the max jax website? All of your questions are answered directly from the people that make it.

http://www.maxjaxusa.com/specifications.html

The max jax is basically a 2 post, just shorter

Mid rise are much different. A 2 post is nicer IMHO for overall work, especially rear wheel drive cars. However 2 post have to be installed and take up a bit more space.

http://www.bendpak.com/car-lifts/specialty-lifts/md-6xp.aspx


I'd recommend you read through both of the links I provided for you, I think alot of your questions will be answered. It always amazes me, people are willing to spend a large sum of money, yet don't want to put in the effort to do any research themselves. :dunno:

Permanently installing a lift outside is a pretty bad idea, especially in a climate like NJ IMHO, it has been covered on here numerous times. Majority of the time, the consensus is that it is a bad idea.
 
Last edited:
To avoid these ads, REGISTER NOW!
OP
A

airbrushguy

Well-known member
Joined
Nov 24, 2011
Messages
55
" It always amazes me, people are willing to spend a large sum of money, yet don't want to put in the effort to do any research themselves."

Actually this post is part of my research process.
I wanted actual responses from someone who might own a 4-5000 lb sedan and the convenience of using a 7000 pound capacity lift with it. I've seen and read alot about corvettes on them but their size and weight is much different.

I guess I was just wondering about possibilities and not at the "spending large sum of money stage" more at the " i've always planned on altering the garage and putting a full two post lift in someday, but saw all the posts about Maxjax and wondered if that would work for me" stage.

Thanks
 
To avoid these ads, REGISTER NOW!
Top Bottom