To avoid these ads, REGISTER NOW!

Acorn Platen table - NJ 07882

P

PowerDubs

Well-known member
Joined
Jan 20, 2009
Messages
406
I have an Acorn welding table that is 5 foot by 2 1/2 foot.

Perfect size for your garage. Has a grounding post welded to the lower rear leg.

It is HEAVY (over 1,000 pounds) so you will need a proper way to transport it (think liftgate)

There is one small corner piece cracked off underneath where the platen meets the frame. It doesn't effect anything whatsoever.

Comes with 2 clamps and several other attachments.


TablePainted.jpg
 
Last edited:
To avoid these ads, REGISTER NOW!
A

A_Pmech

Well-known member
Joined
May 8, 2007
Messages
8,002
Location
IL
Please post a price or I have to delete this thread.

Thanks!
 
To avoid these ads, REGISTER NOW!
OP
P

PowerDubs

Well-known member
Joined
Jan 20, 2009
Messages
406
To answer a few questions I've been asked-

The table height with the wheels is 35 3/4 inches.

I am also including pictures of the cracked corner.

Each corner has 2 'holes' from the factory, 1 on each side.. my guess is to hook something to it to allow the top to be lifted. At some point, someone must have banged one corner hard enough to snap off a small section of one corner. It is in the back where you can't see it and doesn't affect usage in any way.


Normal-

IMG_0786.jpg



Broken-


IMG_0784.jpg




Whole table-

If nobody buys it, I am going to paint the letters black.


IMG_0788.jpg
 
OP
P

PowerDubs

Well-known member
Joined
Jan 20, 2009
Messages
406
PM's returned.

Just to clarify.. because yes, I was asked.. it will cost you a LOT to have this shipped from NJ to CA. ;)
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom