To avoid these ads, REGISTER NOW!

Adding a toilet.

papawfalcon

Member
Joined
Oct 18, 2011
Messages
19
I want to add a toilet and sink in my garage.It will be in an outside corner and thought I could dig a trench under the slab. The problem is what is the best way to cut a hole for the water line and a hole for the toilet drain. Thanks Ken.
 
To avoid these ads, REGISTER NOW!

wb2vsj

Well-known member
Joined
May 30, 2012
Messages
110
Location
East Coast
Boy, you are a glutton for punishment :)

How thick is the slab? Hammer drill a circle and then hammer/chisel out the center?

Have you considered a raised platform for the toilet then exiting out the side of the wall? I don't know what your climate is - you may/will have to insulate if you do this.
 

Brian_B_

Well-known member
Joined
May 12, 2012
Messages
505
Location
North Central, AR
At some point in the past :dunno: someone added a toilet, big fiberglass utility sink, and the washer\dryer hookups in my garage. They busted out the whole section of concrete and put all the necessary pipes in and then re-poured that whole area.

It is walled off into a room. The only way you can tell..is under the door itself...you can see the crack and a very very very slight change in the color of the concrete.

I love it! Working in the garage I have a half bath and do not have to track through the house. The big sink is great for washing up and some parts washing.

I am sure others will chime in on the how to side, but it is well worth it IMHO.
 
OP
P

papawfalcon

Member
Joined
Oct 18, 2011
Messages
19
Ask and you shall receive. Maybe easier said than done I really appricate the feed back. Will have lots of food for thought.Thanks Ken
 

Bib Overalls

Well-known member
Joined
Dec 4, 2006
Messages
3,318
Location
Jonesboro, Arkansas
You can make the hole with a heavy duty hammer drill from a tool rental. Drill a circle of 1/2" holes close together and bust it out. This is a nasty, dirty job. I know, I've done it. Always a risk of cracking the slab. And then there is the digging. Undermining a slab requires more hole than you would think. Good luck.
 
To avoid these ads, REGISTER NOW!

Daniel Dudley

Well-known member
Joined
Sep 4, 2009
Messages
3,546
You could core drill it and get a perfect round hole.

This is what I did. I dug under the slab, and core drilled 5 inch holes, one for the waste line and one for the water line. The drill had a vacuum base that sucked down on the concrete, and it flushed the hole with water. took me an afternoon to drill two holes through 14 inches of concrete.
 
To avoid these ads, REGISTER NOW!
Top Bottom