Aluminum "cutoffs" source?

[scopx]

Am wanting to install set of lifting strakes on pontoon boat to relieve symptoms of plowing and need source of "drops" or waste portions of aluminum sheet panels. I did post in a welding forum and got lot of views, but no replies. Am in relatively close proximity to Austin, San Ant, and Houston areas.
Want any reasonable up to and including 1/8"
Thanks

 

[Red Green]

I have a friend that works at a factory where they make the Panel trucks like UPS uses. Race car shops sould have drops from .040 sheets.

 

[scopx]

Thank You Red, will try that source type.
Am surprised to get only one response with over 150 views.

 

[gorilla]

Try local sheet metal shops they often have drops in their racks, , aluminum is not that expensive buying a full sheet may improve the quality of your work and save you time.

 

[shadow images]

Any metal supplier will have remnants you can buy at scrap prices.