scattermaster
Member
Hey guys,
I'm a not quite retired yet hydraulics guy in Houston.
Tryin to get my man cave set up before retirement.
I've been the mechanical type all of my life. In the last couple of years I've acquired a bench top mill and a 12x36" lathe and various other odds and ends.
My current shop is only 20x12 ft. and it's so cramped I can't hardly work.
In addition to that, I don't even have a garage. I work on my vehicles in the yard or in the street. It *****.
Well,
I finally got the funding put together and I'm getting a shop.
It'll be 30X35ft. with 12ft high walls. Two, 10x10 roll up doors so I can pull my boat in, drop the trailer and drive out the other side.
The rest of the area will be for fabrication of what ever my needs are at the time .
Dirt work starts tomorrow!
This looks like a relatively active forum and I'm gonna have a lot of questions.
thx,
Jim
I'm a not quite retired yet hydraulics guy in Houston.
Tryin to get my man cave set up before retirement.
I've been the mechanical type all of my life. In the last couple of years I've acquired a bench top mill and a 12x36" lathe and various other odds and ends.
My current shop is only 20x12 ft. and it's so cramped I can't hardly work.
In addition to that, I don't even have a garage. I work on my vehicles in the yard or in the street. It *****.
Well,
I finally got the funding put together and I'm getting a shop.
It'll be 30X35ft. with 12ft high walls. Two, 10x10 roll up doors so I can pull my boat in, drop the trailer and drive out the other side.
The rest of the area will be for fabrication of what ever my needs are at the time .
Dirt work starts tomorrow!
This looks like a relatively active forum and I'm gonna have a lot of questions.
thx,
Jim