Trowser Chilli
Member
Hi gang.
I'm currently prepping my garage and hanger floor for epoxy. I've only my garages in the past with materials from Lowes.
So far I have ground and etched the floors. They are ready. They were bare concrete before with very few stains on them.
My biggest question is materials to use.
The hanger floor with have small aircraft, motorcycles, classic cars etc parked on them. Not a lot of day to day traffic however.
The garage will have a mower and daily in and out single car traffic.
I'm trying to decide on just two coats of Armorseal 1000Hs, second coat with some shark grip in it.
OR
One coat of Armorseal 1000Hs and a top coat of Rexthane with shark grip.
I've noticed some on the web saying stay away from the Rexthane if you've never used it or lack experience with it.
Maybe two coats of Armorseal is sufficient for my use?
Best regards
I'm currently prepping my garage and hanger floor for epoxy. I've only my garages in the past with materials from Lowes.
So far I have ground and etched the floors. They are ready. They were bare concrete before with very few stains on them.
My biggest question is materials to use.
The hanger floor with have small aircraft, motorcycles, classic cars etc parked on them. Not a lot of day to day traffic however.
The garage will have a mower and daily in and out single car traffic.
I'm trying to decide on just two coats of Armorseal 1000Hs, second coat with some shark grip in it.
OR
One coat of Armorseal 1000Hs and a top coat of Rexthane with shark grip.
I've noticed some on the web saying stay away from the Rexthane if you've never used it or lack experience with it.
Maybe two coats of Armorseal is sufficient for my use?
Best regards