Anybody have vinyl mats

[PWC Repair]

My wife found these rolls of vinyl mat on the facebook yardsale page. Thought I'd roll a bit out in front of the door and my workbench. They are 3 ft wide. The raised cicle pattern has about 30 ft on it and the diamond plate is about 12 ft. Best part..........she bought them for $5 a roll

Would like to see pics of how you have used this type stuff.

 

[The Cobbler]

that deserves a "YOU ****"

 

[Garage Flooring]

My wife found these rolls of vinyl mat on the facebook yardsale page. Thought I'd roll a bit out in front of the door and my workbench. They are 3 ft wide. The raised cicle pattern has about 30 ft on it and the diamond plate is about 12 ft. Best part..........she bought them for $5 a roll

Would like to see pics of how you have used this type stuff.

We sell a lot of vinyl flooring and its different from what you have. Looking at what you have it has two layers on it and is made overseas. Still a great deal and heck I'd use it for what you are.

We have lots of pics of vinyl flooring from actual customers on our site. Personally I love the G-Floor small coin, but I have to admit I went with garage floor tiles in the showroom and in my own garage (this last time around)

 

[zmotorsports]

I had some vinyl or some form of poly/rubber blend anti-fatigue mats at my last shop in front of my two workbenches and in front of each my lathe and mill. I was experiencing some planar fasciitis for a bit and this seemed to have helped. The bad thing was the hot metal shavings would imbed themselves into the mats around my mill and lathe, the workbenches were fine.

I have been looking at some nicer material for my new shop but haven't pulled the trigger and purchased any yet. I think what you picked up will work perfect as long as you don't subject them to the hot metal shavings like I did.