TomB19
Well-known member
I ordered the Kraftform Kompact from KMStools and the bit storage area doesn't open easily.
The unit I received was an open box (although I ordered a new one) with obvious wear but there are no visible signs of abuse. I would only be mildly annoyed by that, if the tool worked properly.
How easily should it open?
When I press the button to open the bit compartment, I have to press really hard and wiggle to open it. Is this normal? Every review I have read gushes on this tool and the quality so I have a hunch I just have one that isn't quite 100%.
The Wera Rapidaptor this thing is built around is nothing short of amazing, IMO. I ordered this driver based on another Rapidaptor I've been using in an impact and it is fantastic. This one is just as good as the one I've been using for the last few months.
The unit I received was an open box (although I ordered a new one) with obvious wear but there are no visible signs of abuse. I would only be mildly annoyed by that, if the tool worked properly.
How easily should it open?
When I press the button to open the bit compartment, I have to press really hard and wiggle to open it. Is this normal? Every review I have read gushes on this tool and the quality so I have a hunch I just have one that isn't quite 100%.
The Wera Rapidaptor this thing is built around is nothing short of amazing, IMO. I ordered this driver based on another Rapidaptor I've been using in an impact and it is fantastic. This one is just as good as the one I've been using for the last few months.