AquArmor Gloss Topcoat

[ron in sc]

Anyone use or hear anything good or bad about AquaArmor Gloss Topcoat? It's made by General Polymers a company owned by Sherwin Williams. It's a high solids water-based epoxy system that can be used as a concrete sealer. See link below.
http://www.generalpolymers.com/products/pdf/Aquarmor.pdf

 

[Kingham]

Anyone use or hear anything good or bad about AquaArmor Gloss Topcoat? It's made by General Polymers a company owned by Sherwin Williams. It's a high solids water-based epoxy system that can be used as a concrete sealer. See link below.
http://www.generalpolymers.com/products/pdf/Aquarmor.pdf

I'm not a big fan of General polymers.. had a few failures of thier CRU top coat product a few years ago that cost me a lot of money redoing the floors.

Had the rep out to the job site but couldn't come up with a solution or a fix or at least tell me if it was operator error (which it wasn't)

They have since discountinued that product... So maybe this one is the replacement.

As I have stated before.. Dural makes good products. www.concrete-floor-coatings.com

they have a water based top coat that works...

 

[CamarosRus]

Any specific knowledge facts from actual installer or owner of Aquarmor
Coated concrete slab ???