Cantaloupeman
Member
So I'm looking at buying a set of torx screwdrivers and have been considering the channellock USA 5pc set because they are only 13.56 for USA made drivers. Has anyone used these? If so are they pretty good quality?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Are Channellock USA Screwdrivers good?
- Thread starter Cantaloupeman
- Start date
GrantCee
Well-known member
They're your basic Pratt-Read drivers, meaning they're a good value given the quality — though I've heard people complain about the handles being too small.
You can find drivers that fit fasteners more precisely than those, but they'll also be more expensive.
You can find drivers that fit fasteners more precisely than those, but they'll also be more expensive.
Last edited:
Cgw1984
Banned
They are ok. Have you checked bondhus?
No experience, but Bondhus is a better bet for similar money.
https://www.homedepot.com/p/Bondhus-TORX-Screwdriver-Set-with-ProGuard-8-Piece-34532/302015261
Also, look at the Tekton Trilobe set, the screwdriver set is awesome.
https://www.tekton.com/torx-screwdriver-set-26905
https://www.homedepot.com/p/Bondhus-TORX-Screwdriver-Set-with-ProGuard-8-Piece-34532/302015261
Also, look at the Tekton Trilobe set, the screwdriver set is awesome.
https://www.tekton.com/torx-screwdriver-set-26905
between those two, Tekton have the better handles (though the Bondhus handles aren't bad, just basic) and bondhus I would say have the better metal. I have a set of Tekton screwdrivers although not their torx, and I have those same Bondhus drivers. I am basing this on how well the P2 driver has held up (the one I use the most) compared to relatively new Bondhus torx driver set compared to most used Bondhus torx L key.
metaldad
Well-known member
current generation of channeys are fine