Armorpoxy applied in the winter?

[70datsun]

I'm just about at the point with my new garage build where I'm ready to put down my Amorpoxy coating. Even though Albuquerque has a relatively mild climate, it's been just below freezing at night and topping out in the low 50s during the day. Has anyone tried applying this coating in colder temps? I worry that even if I get the air temperature in the garage to a decent level that the slab will still be too cold. Any thoughts?

 

[Armorpoxy]

Hi
It really doesn't matter about the 'outside' temps very much, what does matter is the inside temp which is often much warmer than the outside. A small electric heater can be used, just keep the temp inside the garage north of 50 and you should be fine. If you can't keep the inside above 50, then wait please.

 

[70datsun]

Hi
It really doesn't matter about the 'outside' temps very much, what does matter is the inside temp which is often much warmer than the outside. A small electric heater can be used, just keep the temp inside the garage north of 50 and you should be fine. If you can't keep the inside above 50, then wait please.

Okay, thanks. I should be able to keep it above 50.