To avoid these ads, REGISTER NOW!

Armorpoxy now or in spring

MT Mike

Well-known member
Joined
Feb 21, 2016
Messages
171
Location
Helena MT
Armorclad now or in spring

1st time poster, long time lurker.

After weeks of research and reading I have decided to apply Armorclad to my 24'x24' garage floor. The garage was built around 1980. Concrete is in decent shape, a few hairline cracks, a few minor oil stains. I will do full prep and primer prior to applying the Armorclad. My first issue is, it will be another week to ten days before taping and painting of fresh drywall is done. This puts me into early to mid November before I'm ready to apply the coating. My second issue is, I currently have a gravel driveway. Plans are to pave in early spring. Given that I live in Montana, should I wait until spring to apply the Armorclad, thereby avoiding cold weather and gravel damage?

Let me know your opinions please.

Thanks.
 
Last edited:
To avoid these ads, REGISTER NOW!

Ol'WhiteCap

Well-known member
Joined
Jan 26, 2016
Messages
134
Location
Henderson, CO
Just an opinion, but I say, wait until spring. After you pave your driveway. Also temps in Montana may not be conducive for the drying process.
 

Danno1

Well-known member
Joined
Oct 16, 2014
Messages
1,425
Location
Mass. Northshore/Merrimack Valley
.



Not an opinion, wait until spring.

I caught the last warm day in Oct when I did mine (years ago). I was paying very close attention to weather reports. Epoxy needs to be warm (but not hot!) to cure properly.


PS. Epoxy cures (chemical reaction), not dries. There's a difference.



.
 
To avoid these ads, REGISTER NOW!

Shea

Well-known member
Joined
Sep 19, 2012
Messages
2,872
Location
California
I missed this thread. The advice above is good. You are best to wait till spring after you pave your drive. If you do it now, you run the risk of marring up an nice floor.
 

Armorpoxy

Well-known member
Joined
Aug 18, 2013
Messages
3,735
Location
NJ
Hi
If the temps are below 50 during the curing process in the garage (you can add a space heater if that helps) then wait until spring. While outside temps can be colder, often the temps in the space are higher. We also offer low temp/fast curing systems if you want to get this done now. Please call us for info, or see

https://armorpoxy.com/garages-indoor-residential/ultrafast/
 
To avoid these ads, REGISTER NOW!
Top Bottom