Baldor (and Others) Rubber Feet Replacement

[gregaz]

Please forgive me if this has been discussed elsewhere - I promise I searched first.

I have a Baldor grinder that has dried out, collapsed rubber feet. Is there a replacement someone has found out there that works? Picture below of what I have.

Thank you!

 

[mattblast]

I’ve purchased some from eBay that worked well on my Baldor grinder. Less than $2 for a pack of 10 and that’s with shipping!

https://www.ebay.com/i/252332942845

 

[gtodoc]

I ordered some from Mcmaster Carr

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[gregaz]

I’ve purchased some from eBay that worked well on my Baldor grinder. Less than $2 for a pack of 10 and that’s with shipping!

https://www.ebay.com/i/252332942845

How is the fit?

 

[Buckgnarly]

Subscribed, my Baldor is making a racket when spinning down. Those EBay ones look too small for a big Baldor...

 

[mattblast]

How is the fit?

The feet aren’t exact match for Baldor but they do fit and look fine (and prevent grinder from walking).

Here some installed on a grinder I restored. (This ones not a Baldor)

 

[saryon7]

You can buy those at home depot and lowes. It is in the hardware section near the hinges. There is a section of these feet and the type of feet they use for sliding furniture around.

 

[gregaz]

Thanks, all. I am going to take my chances with the eBay set. $1.33 TOTAL for 10 pieces is not that much of a risk ... I will be in touch!

 

[gregaz]

Just got mine, and installed them. Great fit - if I was pickier I would grind them down, but no matter how you look at it - for $1.33 for TEN, I can't complain.

Here are some fit photos.