You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Banana plug test lead connector ?
- Thread starter Jbullfrog
- Start date
What would you call this? I would like to get another set for my test leads, as this one doesn't have continuity. This is a male male connector.
take a measurement of that pin in the plug in mm (metric) and the distance between the two plugs (center to center)
and maybe google for
test plug jumper ?
bananna plug jumper?
4 mm test plug jumper?
4 mm test plug ?
I "think" there are two different sizes the one for instruments is different from the ones on a multi meter stuff... but don't quote me.
theoldwizard1
Well-known member
It called a Double Banana Plug with Shorting Bar - Pomona MDP-S* (* = 0 - Black, 2 - Red, 9 - White)
engineer2
Well-known member
Dual banana plug.
Bobioz1
Well-known member
What would you call this? I would like to get another set for my test leads, as this one doesn't have continuity. This is a male male connector.
Looks like the 2ohm resistors I got in a test lead set from a link on the GJ. I figured they were for airbag substitution. If yours is open circuit you probably toasted the resistor inside. There was two similar pieces in the kit that were black with 2 male and 1 female banana that were for test lead jumpers.
Looks like the 2ohm resistors I got in a test lead set from a link on the GJ. I figured they were for airbag substitution. If yours is open circuit you probably toasted the resistor inside. There was two similar pieces in the kit that were black with 2 male and 1 female banana that were for test lead jumpers.
Garage Journal is way better then the instructions that didn't come with these sets. This is from the test lead set that Andy, one of our members had a pallet of. Now I know there is a difference between the yellow and black ones.
Thanks,